Reinforcing bar reinforcement is to connect building components and components through the cooperation of building reinforced adhesive and steel bars to achieve the effect of reinforcement. The quality of building reinforced adhesive reinforcement depends on the quality of building reinforced adhesive. Good building reinforced adhesive has many advantages for the building. It can be capable of fast loading, shock resistance, shock resistance, fatigue resistance 2 million times, resistance to hot and humid aging for 50 years, resistance to acids and alkalis, no creep, etc. So what do you need to pay attention to when strengthening the buildings with reinforced adhesive?
1. Drying in the holes of planting tendons. If the reinforcement of planting tends to be effective, it must be dry when drilling, because water or moisture will affect the solidification of the planting tendons.
2. Impurities in the holes of planting tendons. If there are crushed stones and dust in the holes, it will also affect the solidification of the planting tendons, so use a hairdryer to blow out the impurities inside.
3. Welding can only be performed after the curing, otherwise the short-term high temperature will invalidate the glue;
4. Avoid low-temperature weather. If the temperature is too low, it will also affect the solidification of building reinforced adhesive;
Then, for the points mentioned above, is there any way to solve it at a time, that is, Mankate's MT-500 building reinforced adhesive. MT-500 building reinforced adhesive has the following special advantages:
1. Strong seawater resistance; it can be cured in water.
2. It can meet the requirements of all-weather operation, and can be used in impact drilling and coring wet holes.
3. Almost any drilling diameter and implantation depth can be applied.
4, with high strength of anchoring binding force.
5, with high compressive strength and high bearing capacity.
6. It has higher strength than the concrete around it after curing.
7. There is almost no shrinkage during the curing process.
8. The effect of the hole diameter on the anchoring force is small. When small-sized anchors are implanted in large-sized holes, the anchoring force can be enhanced.
9. Can be used for solid concrete and granite.
10. Does not crystallize and can be cured at low temperature.
11. Fully mixed by the mixer; the glue injection construction is convenient and simple.
12. One product can meet multiple substrate applications. Good adhesion with most structural materials.
13. High temperature resistant type can serve 135 degree environment for a long time, and can serve 200 degree environment instantly.
Mankate MT-500 building reinforced adhesive, no fear of high temperature and water
So all of the above matters can be solved at a time. Why are you still hesitating? Come and buy it. Phone number: 400-894-5118
Editor: Nanjing Mankate, if you need to reprint, please indicate the source
Original link: https://www.njmkt.net/
