Accidents of house collapse often occur. Some time ago, we found a house collapse accident when browsing the web news. A street building in Kuancheng District, Changchun, Jilin Province collapsed partially. Only one old man lived in the incident building, and the old man was buried after the house collapsed. At present, the elderly man has been rescued and sent to hospital, and no other casualties have occurred. Although there was still no danger in the back, the trapped old man was successfully rescued. However, in recent years, the collapse of old houses has emerged in an endless stream. There is only one chance for life. Shouldn’t the family be a warm harbor? In the face of the danger of housing collapse, how should we prevent it?
Don't wait until the house collapses and regret to buy the bad structural reinforced adhesive!
A good way to prevent house collapse is to check the condition of the house regularly. Once the wall is cracked, the wall ash falls, and the foundation sinks. The house should be reinforced in time. At present, the most widely used house reinforcement is the structural reinforced adhesive method.
Then, when using the structural reinforcement method to strengthen the house, what problems should we pay attention to in order to make the strengthened house more secure and reliable? We summed up the following points for everyone.
The first is the quality of the structural reinforced adhesive. The structural reinforced adhesive used in the building must be environmentally friendly and non-toxic. This will not only ensure the health of the construction workers during construction, but also will not be too much toxic gas after the reinforcement of the house. In addition, some of the inferior structural reinforced adhesive on the market is not only extremely toxic, but also makes the quality of the project after reinforcement lower. Everyone can polish their eyes.
Mankate structural reinforced adhesive has good performance and anti-aging for more than 50 years, which is more suitable for house reinforcement!
In the process of reinforcement, the step of reinforcement must follow the construction process of the structural reinforced adhesive. Pay attention to the details of the construction process, and do the “four blows and three sweeps” in the hole cleaning, and use the air compressor to blow the floating debris in the hole. Equipped with a metal brush to clear the hole to ensure that there is no dust in the hole.
There are six steps in the reinforcement process of structural reinforced adhesive. If you have any questions, please call 400-894-5118.
When planting the ribs, it is necessary to ensure that the surface of the steel part of the implanted part is free of rust and no oil stains. Otherwise, it is easy to pull out the whole steel bar during the drawing test, and the anchoring performance of the structural reinforced adhesive will be greatly reduced.
The above is a common problem in the reinforcement construction of structural reinforced adhesive. If you have any problems that cannot be solved in the process of strengthening the reinforcement of the building structure, please call the Mankate one-stop service hotline. :400-894-5118, we will have a professional technician to provide you with a solution that can be referenced.
Link to this article: https://www.njmkt.net/Article/fwttywxycz.html
(Editor: Nanjing Mankate, if you need to reprint, please indicate the source)
